Setting Up Your Kegerator

Of course, a set of clear instructions comes with anythat you screw the screws in tight but not too tight.
newly delivered kegerator that is fresh out of theThis is where most people develop problems and it's
box. If you get one second hand, you might havethe first step you have to do.
problems. If you like throwing instructions awayWe all know how ridiculous air, gaskets and beer can
before you give them a look, you might havebe when the three just aren't getting along. So,
problems. So, here are a few tips to help you getmake sure it's right from the start. Take your time.
your home bar and keg drinking fun up and running inTighten the screws with steady pressure and make
no time.sure your gasket sits right.
First of all, don't throw the instructions away. Haven'tThe next step is probably to install the guardrails. So,
you learned this one already when you were buildinghave fun with that. You can't really screw that up
your daughter's new kitchen set that you bought hertoo much. So moving forward, you'll most likely have
for Christmas? Ok, then. What's up with people stillto setup the regulator next. Place a hose clamp over
throwing away the instructions? Important note,the air line hose at the end that is going to attach to
exchange the daughter kitchen set experience withyour regulator. Now, when you place your air line on
anyone you may have had where you skipped athe regulator valve, you'll be able to slide the hose
step and realized later how drastic of a mistake thatclamp up and tighten. Once again, be careful when
was.you tighten the hose clamp. Tighten sturdy. But,
Moving on, when you open up your box, make suretightening too much can damage the hose and cause
you look through your parts. They should be listeda leak.
close to the beginning of the instructions. Make sureThere should be a CO2 tank holder and you should
you have everything. Plus, make sure you take ause it. Once the tank is in place, put a line clamp on
look at what tools you'll need. Grab them from yourthe air line and attach to the air line valve on the
garage, tool box, tool belt, trunk of your car, toolcoupler. Slide the line clamp up and tighten. Put
drawer, behind the dryer or anywhere else you mightanother line clamp on the beer line and with a seal in
have the tools you need.the wing connector, attach the connector to the
One final note about this particular step, look throughbeer line valve on the coupler. Slide the line clamp up
the instructions real quick to find any item that youand tighten.
might need but don't have. Normally, everything'sNow, it's easy. Make sure that the faucet on the
included. But depending on the kegerator youtower is tight. Then, do what you were born to do.
purchase or the purpose you have for it, you mayTap the keg. If you need instructions for how to do
need to take a trip to the hardware store and grab athat, ask one of your beer enthusiast friends who
few extra items before you get started.are sitting around thirsty and have a seat in the
Depending on the kegerator instructions and thecorner.
particular person who wrote them, you'll begin withOf course, you will have to learn how to clean your
the tower installation. You'll have a gasket to stoplines and I would hope that you do that before you
the air flow and this is one of the most importantdrink your first draft or run your first ounce of beer
steps. Make sure that you line the screw holes upthrough the line. But, at least now you know how to
and that the gasket sits flat. After you thread thesetup your kegerator.
beer line through the airway hole, be very careful